Spohn 704 Manuel d'utilisateur télécharger pdf

Spohn Performance, Inc.

494 E Lincoln Ave Myerstown, PA 17067

1-888-365-6064 www.spohn.net

Part #704 – Tubular K-Member - 1993-2002 GM F-Body

USE OF THIS PRODUCT IS ACCEPTANCE OF SELLER’S DISCLAIMER OF WARRANTY!

By their very nature, competition components are constantly pushed to their limits. While our components

are designed to withstand intense race conditions, it is impossible to control the quality of installation or

the varying conditions in which they are used. It is for this reason that absolutely no warranty or

guarantee is either written or implied. Neither the seller nor the manufacturer will be liable for any loss,

damage, or injury – direct or indirect – arising from the use of or inability to determine the use of any

product. Before using, the user should determine the suitability of the product for its intended use, and

the user shall assume all responsibility in connection therewith. Spohn Performance, Inc. makes no

guarantee as to the legality for any specific class. Spohn Performance, Inc. makes no claims, nor does it

intend its products to be used in street driven vehicles. Spohn Performance, Inc. reserves the right to

make changes in design or add to or improve on their product without incurring any obligation to install

the same on product previously manufactured. The Buyer agrees to indemnify and hold Spohn

Performance, Inc. harmless from any claim, action or demand arising out of or incident to the Buyer’s

installation or use of products purchased from Spohn Performance, Inc.

Required Tools:

Jack and jack stands or service lift

Wrenches - 8mm, 10mm, 11mm, 13mm, 15mm, 18mm

Sockets - 10mm, 13mm, 18mm, 21mm

Various ratchet extensions and universal joints

Pry bar

Brass hammer or pickle fork

Note: These instructions are based on an LS1 car install, some steps may not be

necessary on an LT1 application.

Installation Procedure:

1. Using an 8mm wrench, remove the positive cable on the battery.

2. Using a 15mm wrench, loosen the serpentine belt tensioner and remove the belt

from the alternator.

3. Lift car so that factory k-member is at least 18" from ground. Support car with

jack stands under frame rails.

4. Remove front wheels/tires.

5. Using a 13mm socket and wrench, remove the front sway bar.

6. Using an 18mm wrench, remove both power steering lines and cap hoses to

prevent fluid loss.

7. Using a 13mm and a 15mm socket, remove all 3 bolts holding the alternator in

place, unplug wiring harness, and remove the alternator. This is necessary in order

to access the factory motor mount bolt.

1 2 3

Spohn Performance, Inc 1

Résumé du contenu

Page 1 - Spohn Performance, Inc

1 Spohn Performance, Inc. 494 E Lincoln Ave Myerstown, PA 17067 1-888-365-6064 www.spohn.net Part #704 – Tubular K-Member - 1993-2002 GM F-Body

Page 2

2 8. Support the motor with a jack and a block of wood under the oil pan, or from above with a hoist. 9. Using an 18mm socket and wrench, remove the

Page 3

3 25. Install both motor mount bolts and tighten. This may require using a jack or pry-bar to lift/lower the motor in order to insert the motor mount

Commentaires sur ces manuels

Pas de commentaire

Spohn 704 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Spohn 704. Spohn 704 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Spohn 704