Spohn 741 Manuel d'utilisateur télécharger pdf

Spohn Performance, Inc.

494 E Lincoln Ave Myerstown, PA 17067

1-888-365-6064 www.spohn.net

Part #741 – Tubular Front Lower A-Arms - 1993-2002 GM F-Body

USE OF THIS PRODUCT IS ACCEPTANCE OF SELLER’S DISCLAIMER OF WARRANTY!

By their very nature, competition components are constantly pushed to their limits. While our components

are designed to withstand intense race conditions, it is impossible to control the quality of installation or

the varying conditions in which they are used. It is for this reason that absolutely no warranty or

guarantee is either written or implied. Neither the seller nor the manufacturer will be liable for any loss,

damage, or injury – direct or indirect – arising from the use of or inability to determine the use of any

product. Before using, the user should determine the suitability of the product for its intended use, and

the user shall assume all responsibility in connection therewith. Spohn Performance, Inc. makes no

guarantee as to the legality for any specific class. Spohn Performance, Inc. makes no claims, nor does it

intend its products to be used in street driven vehicles. Spohn Performance, Inc. reserves the right to

make changes in design or add to or improve on their product without incurring any obligation to install

the same on product previously manufactured. The Buyer agrees to indemnify and hold Spohn

Performance, Inc. harmless from any claim, action or demand arising out of or incident to the Buyer’s

installation or use of products purchased from Spohn Performance, Inc.

INSTRUCTIONS

Tools Required:

Wrenches and sockets - 12mm, 13mm, 15mm, 18mm, 21mm

Hydraulic jack and stands

Grease gun

Needle nose pliers

Installation:

1. Raise vehicle and support with stands. Remove both front wheels/tires.

2. Using a 12mm socket, remove the two caliper retaining bolts and slide the

caliper out of the way. There is no need to remove the brake line from the

caliper.

3. Unplug the ABS sensor from the back of the hub. Remove the plastic wire

retaining clips from the lower A-arm and position the ABS wire out of the way.

4. Using a 13mm wrench and a 15mm socket, remove both bolts/nuts on the

lower shock mount.

5. Using needle nose pliers, remove the cotter pins from both the upper and

lower ball joints. Remove the upper ball joint nut using a 15mm wrench.

Using a pickle fork, knock the upper ball joint loose.

6. Loosen the lower ball joint nut using an 18mm wrench and knock the ball

joint loose. Move the spindle/rotor assembly out of the way. If you want to

completely remove the spindle, loosen the tie rod nut using an 18mm wrench

and knock the tie rod loose.

1 2

Spohn Performance, Inc 1

Résumé du contenu

Page 1 - Spohn Performance, Inc

Spohn Performance, Inc. 494 E Lincoln Ave Myerstown, PA 170671-888-365-6064 www.spohn.netPart #741 – Tubular Front Lower A-Arms - 1993-2002 GM F-Bo

Page 2

7. Locate the shock mounting bolts in the engine bay. The rear two are bolts, the front two are studs. Remove the front two nuts using a 15mm wrench a

Commentaires sur ces manuels

Pas de commentaire

Spohn 741 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Spohn 741. Spohn 741 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Spohn 741